Otherwise the display shows:
•
Repeat the previous steps if an error message is displayed,
moving the Switch
iR
closer to the infra-red port.
Setting the low frequency cut filter
The LF cut filter gives an approximately 10dB cut at 50Hz to
reduce handling and wind noise.
To check the status of the low frequency cut filter:
•
Press MENU
•
Press
twice until the display shows:
•
Align the front of the Switch
iR
with the infra-red port on
the transmitter and press OK. The current LF cut filter
setting is displayed; for example:
To change the filter setting:
•
Press OK again. The current setting will flash.
•
Press
or
to toggle between ON or OFF until the
required setting is displayed.
•
Align the front of the Switch
iR
with the infra-red port
on the transmitter and press OK. If the command was
received successfully the new setting will be displayed. For
example:
Otherwise the display will show:
•
Repeat the previous steps if an error message is displayed,
moving the Switch
iR
closer to the infra-red port.
Checking the battery status
•
Press MENU.
•
Press
three times until the display shows:
•
Align the front of the Switch
iR
with the infra-red port on
the transmitter and press OK. The display will show the
current battery status:
The battery level can also be checked from the receiver;
see the appropriate instructions for the receiver.
Infra-red disable
You can protect the HX2040 from an accidental change
of settings, such as in a live performance, by disabling
the infra-red port on the transmitter. This will prevent
all communication to the transmitter until the battery is
disconnected and reconnected.
Disabling the infra-red port
•
Press MENU.
•
Press
twice. The display will show:
•
Align the front of the Switch
iR
with the infra-red port
on the transmitter and press OK. If the command was
received successfully the display will show:
Note: Once the infra-red port has been disabled, any
subsequent interrogation of the transmitter will give an
Error display; this is not a fault.
Fitting the microphone
capsule
The HX2040 transmitter uses high quality interchangeable
condensor capsules from the Schoeps™ Colette range. The
HX2040 is compatible with the full range of capsules and
accessories in this range.
The capsule mounting has a unique gel-based suspension to
minimise handling noise.
To fit a capsule
•
Unscrew the metal windscreen from the top of the
transmitter.
•
Screw the capsule into place taking care not to cross-
thread the capsule or over-tighten it.
•
Replace the windscreen.
Holding the HX2040
The HX2040 should be held above the illuminated On/
Overload indicator ring. This will enable maximum power
to be radiated from the integral antenna in the battery
compartment. Holding the HX2040 over the battery
compartment will impair the range of the transmitter and
should be avoided.
The frequency, gain, and LF status setting will be retained
even if the battery is removed from the transmitter.
An external foam windshield is available from Audio
Limited.
User Guide HX2040 handheld wireless transmitter
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals