Audio House TX2040 User's Guide Page 1

2040 User Guide DX2040 portable true diversity receiver – page 3miniTX miniature pocket transmitter – page 7TX2040 pocket transmitter – page 14HX2040

miniTX Transmitter889Switching off To turn the transmitter off remove the Lemo plug (4-pin Lemo version only), or put the miniTX in sleep mode by swi

miniTX Transmitter8810Setting the gainThe steps between gain settings 2-9 are approximately 3 to 4dB. Set the gain position so that the Overload indi

miniTX Transmitter8811• Press a or v to toggle between ON or OFF until the required setting is displayed.• Align the front of the SwitchiR with the

miniTX Transmitter8812Sleep mode . . . . . . . . . . . . . . . . . . . . . . . .The miniTX can be put into sleep mode using the SwitchiR. In sleep mo

miniTX Transmitter8813Technical specification . . . . . . . . . . . . . . . . . . . . . . . .Frequency range470MHz–1000MHzNumber of frequencies32 pre-

CHAPTER48814Controls, display and connections . . . . . . . . . . . . . . . . . . . . . . . .Top panelAntennaOn (green)Overload (orange)Infra-redportA

TX2040 Pocket Transmitter8815Note: Positions 0 and 1 (8 and 9 on the TX2020) provide line-level input.Setting up the TX2040 . . . . . . . . . . . . .

TX2040 Pocket Transmitter8816The LED flashes green when the battery voltage falls below 6.5V. The unit should not be used when the battery is low as p

TX2040 Pocket Transmitter8817To check the gain setting:• Press MENU followed by a.The display will indicate: AF LEVELTxRx AF • Align the front of

TX2040 Pocket Transmitter8818If the command was received successfully the new setting will be displayed.For example: Tx OnOtherwise the display wil

881CHAPTER1DX2040 . . . . . . . . . . . . . . . . . . . . . . . .The DX2040 true diversity receiver in the RMS2040 range can be used with the TX2040 p

TX2040 Pocket Transmitter8819Putting the TX2040 into sleep mode• Press MENU followed by v. The display will indicate: Tx OFF • Align the front of

8820CHAPTER5Controls, displays, and connections . . . . . . . . . . . . . . . . . . . . . . .WindshieldCan be unscrewed to access the microphone capsu

HX2040 Hand-Held Transmitter8821Setting up the HX2040 . . . . . . . . . . . . . . . . . . . . . . .To set up the HX2040 :• Fit the battery.• Switch

HX2040 Hand-Held Transmitter8822Switching on* Press and hold the grey On button below the infra-red port for one second until the ring above the bat

HX2040 Hand-Held Transmitter8823The display will indicate: AF LEVELTxRx AF • Align the front of the SwitchiR with the infra-red port of the HX2040

HX2040 Hand-Held Transmitter8824Otherwise the display will show: Error • Repeat the previous steps if an error message is displayed, moving the Swi

HX2040 Hand-Held Transmitter8825Holding the HX2040 . . . . . . . . . . . . . . . . . . . . . . .The HX2040 should be held above the illuminated On/Ov

CHAPTER68826<>MenuOKControls . . . . . . . . . . . . . . . . . . . . . . . .VVFREQUENCYMHz FrDisplayScroll buttonsMenu/On button9V batteryteste

SwitchiR Infra-Red Controller8827Using SwitchiR . . . . . . . . . . . . . . . . . . . . . . . .Full instructions for using SwitchiR with each of the

CHAPTER78828Controls, display, and connections . . . . . . . . . . . . . . . . . . . . . . . .Green ON indicatorON button LemoconnectorRed OFF Indicat

CHAPTER1882SwitchiR . . . . . . . . . . . . . . . . . . . . . . . .The SwitchiR is an infra-red remote control unit the size of a key fob, which can b

Control-X Transmitter Controller 8829Switching onTo switch the miniTX or TX2040 on, even through clothing:• Hold the Control-X within 20cm (8")

Control-X Transmitter Controller 8830Checking battery voltages . . . . . . . . . . . . . . . . . . . . . . . .Checking the Control-X battery• Press

Declaration of conformity8831EC Declaration of ConformityDéclaration de conformité pour la CEE EG-Konformitäts-Erklärung Certificato di conformitá com

Declaration of conformity8832EC Declaration of ConformityDéclaration de conformité pour la CEE EG-Konformitäts-Erklärung Certificato di conformitá com

883CHAPTER2Controls, display and connections . . . . . . . . . . . . . . . . . . . . . . . .Bottom panelBatterycompartmentIdentificationplugOn/off swi

DX2040 Receiver884TX/DX low battery indicatorsIlluminate when the unit detects low battery power in either the TX2040 Pocket Transmitter or DX2040 Re

DX2040 Receiver885For example: CHANNEL 01 • Press a or v to scroll through the 32 frequencies read from the receiver until the required channel

DX2040 Receiver886• Repeat the above steps if an error message is displayed, moving the SwitchiR closer to the infra-red port.Checking the DC power

887CHAPTER3Controls, display and connections . . . . . . . . . . . . . . . . . . . . . . . .Top panelAudioinput socketInfra-redportSleep/Low battery(o

miniTX Transmitter888Setting up the miniTX . . . . . . . . . . . . . . . . . . . . . . . .To set up the miniTX:• Fit the batteries.• Connect the an